search

Structuro 343T - Superplasticising additive for tunnel lining concrete

Superplasticising additive for tunnel lining concrete. New generation additive with a high water-reducing power without loss of workability or performance. It allows the production of very fluid concretes.

Consumption: 0.6 - 1.5% by weight of cement.

Container
 

MORE THAN 20 YEARS OF EXPERIENCE

 

SHIPPING IN 48-72 HOURS

 

100% SECURE PAYMENT

Structuro 343T is a new generation additive with a high water-reducing power without loss of workability and performance. It allows the production of very fluid concretes.

Uses

  • Specially designed for making self-compacting and self-levelling concrete.
  • Concrete for lining tunnels.
  • For all types of concrete requiring a normal workability period, high initial strength and high performance.

Advantages

  • High water reducing power.
  • Significant improvement in both initial and final mechanical strength.
  • Provides a stable and very homogeneous concrete.
  • Allows the production of extremely fluid concrete for use on site without the need for vibration.

Standards

Structuro 343T complies with UNE-EN 934-2:2010 Tables 3.1. and 3.2. as a high activity water reducer / superplasticiser.

Typical dosage

The optimum dosage of Structuro 343T to achieve specific requirements should be determined by tests using the materials and conditions with which it will be tested in practice.

This dosage can range from 0.6 to 1.5% s.p.c.,. For self-compacting concrete the average dosage would be approximately 1%.

Properties

The following results were obtained at a temperature of 20ºC:

  • Appearance: Brown liquid
  • Density: 1,05 ± 0,01 kg/l
  • pH: 6,0 ± 1,0
  • Water soluble chloride content (CI-): ≤ 0,10%.
  • Alkaline content (Na2O equivalent): max. 2% by mass
  • Main function: Decrease water content. Increase workability
  • Secondary function: To increase initial and final strengths.

Mode of use

Mixing design

Once the appropriate dosage has been selected, care must be taken to ensure the consistency of the materials used and the mixing and distribution processes.

Compatibility

Structuro 343T is only compatible with superplasticisers from the Fosroc Euco range if the lowest possible w/c ratio is to be maintained. If more than one admixture is used, they should be added to the concrete separately and not mixed together prior to addition. The resulting properties of concrete containing more than one admixture should be checked by pre-testing.

Structuro 343T is suitable for use with all cements complying with RC-08.

Dosing system

The correct amount of Structuro 343T should be measured using a suitable dosing system. For best results, the admixture should be added to the concrete in the mixing water or directly into the mixer at the same time as the water.

Contact the Fosroc Euco Technical Department for advice on the appropriate dosing equipment and its installation.

Effects of overdosage

An overdosage of twice the maximum dosage indicated may cause a delay in the setting of the concrete as well as an additional air lock.

Curing

As with all structural concrete, good curing must be achieved, particularly in situations where overdosing has occurred. A Fosroc Euco Concure type curing membrane, water (sprayed) or wet burlap should be used.

Clean up and disposal

Spillage of Structuro 343T should be absorbed with sand or earth and transferred to suitable containers. Product residues should be flushed away with a large quantity of water. Disposal of the product and packaging is the responsibility of the end user.

Storage

Structuro 343T has a storage life of 12 months if kept in dry conditions in its original, sealed containers at a temperature between 2ºC and 40ºC. The colour of the additive may change over time, without affecting the properties of the additive.

Precautions

Safety and Hygiene

Structuro 343T must not be swallowed or come into contact with skin and eyes. Wear protective gloves and goggles. Splashes on the skin should be washed off with water. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. If swallowed, seek immediate medical attention. Do not induce vomiting.

For further information, please refer to the Material Safety Data Sheet.

Fire

Structuro 343T is water based and non-flammable.

Fosroc

You might also like