search

Conplast R1 - Setting inhibitor additive for shotcrete

Setting inhibitor and retarder additive for shotcrete. Colourless liquid based on organic acids compatible with other Fosroc additives used in the same concrete mix.

Consumption: 0.2 - 0.5% of the weight of the cement.

(CONFIRM MANUFACTURING TIME)

Container
 

MORE THAN 20 YEARS OF EXPERIENCE

 

SHIPPING IN 48-72 HOURS

 

100% SECURE PAYMENT

Conplast R1 is a colourless liquid based on organic acids that provides a setting delay for shotcrete.

Uses

  • Conplast R1 is designed to maintain the workability of wet sprayed concrete until application. 
  • Shotcrete delayed with Conplast R1 can be accelerated after the delay time by using Sprayset AL or Sprayset HBL44 liquid accelerator.

Advantages

  • Controlled retardation extends the workability period and setting time.
  • Compatible with all types of cement.
  • Chloride-free, can be used in prestressed and reinforced concrete.

Standards

Conplast R1 complies with UNE-EN 934-2:2010 +A1 Table 8 as a setting retarder.

Typical dosage

The optimum dosage of Conplast R1 to achieve specific requirements should be determined by testing, using the materials and conditions that will be used in practice.

A starting point for such trials is to use a dosage between 0.2 and 0.5 litres of Conplast R1 per 100 kg of cementitious material, including ash, slag or microsilica.

Laboratory tests have shown that at a dosage of 0.5 %, the concrete remains workable for more than 8 hours.

Properties

The following results were obtained at a temperature of 20°C:

  • Appearance: Yellowish liquid.
  • Density: 1,213 ± 0,01 kg/l
  • pH: < 2,0
  • Water soluble chloride content (CI-): ≤ 0,10%.
  • Alkali content (Na2O equivalent): max. 5 mass %.

Directions for use

Compatibility

Conplast R1 is compatible with other Fosroc admixtures used in the same concrete mix. If more than one admixture is used, they must be added to the concrete separately and not mixed together prior to addition. The resulting properties of concrete containing more than one admixture must be checked by prior testing.

Conplast R1 is suitable for use with all cements complying with RC-08.

Effects of an overdose

An overdose of twice the amount of Conplast R1 may result in air locking which tends to reduce strength. The degree of this effect will depend on the particular mix and the level of overdosing.

Mixing

The admixture should be added to the concrete with the mixing water for best results.

Curing

The final characteristics of any structural concrete will depend on good curing practice. It is therefore very important to use a Fosroc Euco Concure curing membrane, water spray or wet burlap.

Storage

Conplast R1 has a maximum storage period of 12 months, provided it is kept at a temperature between 2 ºC and 50 ºC. If the temperature exceeds this range, contact Fosroc Technical Department.

Precautions

Safety and Hygiene

Conplast R1 must not be ingested or come into contact with skin and eyes. Wear protective gloves and goggles. Splashes on the skin should be washed off with water. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. If swallowed, seek immediate medical attention. Do not induce vomiting. 

For further information see Material Safety Data Sheet.

Fosroc

You might also like